Implant Supported Over-Denture

Scroll to product description..

Implant Prosthesis

Place Order

Implant Supported Over-denture - is a type of over denture that is supported by and attached to implants. A regular denture rests on the gums, and is not supported by implants. An implant-supported denture is used when a person doesn't have any teeth in the jaw, but has enough bone in the jaw to support implants.

Implant-supported Overdentures is a fixed framework offered in various material options namely:

vFixed framework (Ti Milled)

vFixed framework (Ti Casting)

vFixed framework for Overdenture (Ti Casting)

vFixed framework for Overdenture (CoCr Casting)

v  Minimum number of implants required is at least 2 per jaw.

v  Removable for easy care.

v  Structured to give full implant-supported function.

v  Restores quality of life in a cost effective and timely manner.

v  Preserves the bone and prevents further deterioration of facial structure.

v  Prevents health problems that would normally occur with complete tooth loss.


vSevere morphologic compromise of denture supporting areas that significantly undermine denture retention.

vPoor oral muscular coordination

vLow tolerance of mucosal tissues.

vParafunctional habits leading to recurrent soreness and instability of prostheses.

vActive or hyperactive gag reflexes, elicited by a removable prostheses.

v  Warranty regarding extension, retention, occlusion, contact etc. is only on the basis of the given model.

v  All repetitions and correction should be informed within 7 days and will be accepted only with fresh models along with initially supplied model, work and warranty card.

v  To claim warranty of Pine Dental prosthesis, the patient should consult the same doctor or clinic.

v  Repetitions will be charged at 50% of the actual rate of the work and additional tax, if any.

v  Patient cannot claim warranty in the pricelist will not have any warranty.


v  We need 7 working days to complete a work except Friday and other holidays.

Urgent Orders

v  Will be charge 10% extra. The fabrication time depends on prosthesis type and unit.


v  The proximal margins of the abutments should be parallel or slightly tapering towards occlusal surface. Eliminate undercuts to the maximum. Round all corners.

v  We always prefer perfect rubber base impression. Don’t pour die stone type IV immediately to the rubber base impression. Pour only after 1 hour.

v  Don’t allow the alginate impression to get dried. Pour die stone type IV immediately. If the model thus prepared is found defective (air bubble, broken stump etc.) discard it and take a new impression rather than trying to produce a second model from the old alginate impression.

v  We need upper and lower full Die Stone IV models to check the occlusion correctly.

v  Provide the bite registration in Silicone putty (not in wax), if necessary.

v  The shade will be perfect only if the labial and occlusal clearance is 2mm.

v  VITA classical and VITA 3D Master 9of Ivoclar A-D shade number should be given for ceramic shade selection.

v  Avoid grinding the metal prosthesis at the time of metal trial. This may lead to contamination of metal and ceramic chipped – off.

v  In anterior case, if the patient is satisfied with the temporary crown / bridge, kindly provide a model of that which will help us in imitating the shape and arrangement. Pre – operative models will also be useful in some cases. 

Other Products

Study Model

A dental impression is a negative imprint of hard (teeth) and soft tissues in the mouth from which a positive reproduction

Get Details



Lightweight for outstanding patient comfort (over 35% lighter than chrome castings and more

Get Details

Cocr & Ti


Is reliable processing in the modern injection molding systems offers the possibility

Get Details


Nance Appliance

Is used as an anchorage appliance to hold molars in place while the patient continues with traditional bands and

Get Details

Nance Appliance