We are committed to providing the dental profession with state-of-the-art and cost-effective implant
A dental implant is placed in the jawbone so that it can fuse with your natural bone and become a strong and sturdy foundation for replacement teeth. Implants can be used to replace an individual tooth or for an implant-supported bridge or denture containing multiple teeth.
The additional expense of a custom abutment is only necessary about 10% of the time. It can increase the cost of the dental implant by about 10%. The best way to avoid making a custom abutment is for your implant to be placed correctly.
v Customized shape and emergence profile
v Control over cement gap
v Optimized path of insertion
v High convenience in the restoration
vTheir advantages, including patient-specific soft tissue management during the healing phase and final restorations that adhere precisely to the patient’s gingival architecture, make them an excellent option for implant treatment.
v Warranty regarding extension, retention, occlusion, contact etc. is only on the basis of the given model.
v All repetitions and correction should be informed within 7 days and will be accepted only with fresh models along with initially supplied model, work and warranty card.
v To claim warranty of Pine Dental prosthesis, the patient should consult the same doctor or clinic.
v Repetitions will be charged at 50% of the actual rate of the work and additional tax, if any.
v Patient cannot claim warranty in the pricelist will not have any warranty.
need 7 working days to complete a work except Friday and other
v Will be charge 10% extra. The fabrication time depends on prosthesis type and unit.
v The proximal margins of the abutments should be parallel or slightly tapering towards occlusal surface. Eliminate undercuts to the maximum. Round all corners.
v We always prefer perfect rubber base impression. Don’t pour die stone type IV immediately to the rubber base impression. Pour only after 1 hour.
v Don’t allow the alginate impression to get dried. Pour die stone type IV immediately. If the model thus prepared is found defective (air bubble, broken stump etc.) discard it and take a new impression rather than trying to produce a second model from the old alginate impression.
v We need upper and lower full Die Stone IV models to check the occlusion correctly.
v Provide the bite registration in Silicone putty (not in wax), if necessary.
v The shade will be perfect only if the labial and occlusal clearance is 2mm.
v VITA classical and VITA 3D Master 9of Ivoclar A-D shade number should be given for ceramic shade selection.
v Avoid grinding the metal prosthesis at the time of metal trial. This may lead to contamination of metal and ceramic chipped – off.
v In anterior case, if the patient is satisfied with the temporary crown / bridge, kindly provide a model of that which will help us in imitating the shape and arrangement. Pre – operative models will also be useful in some cases.
Is an excellent material choice for metal – free restorations because of its biocompatibility, strength, durability and beauty.
Zirconia crowns allow light to pass as a normal tooth would and that gives a natural look, unlike other metal cores that block the light...
Is an appliance that is custom-made by a dentist or orthodontist in acrylic or metal material.