Quad Helix Appliance

Scroll to product description..

Ortho Appliances

Place Order

Quad Helix Appliance ­- is an orthodontic appliance for the upper teeth that is cemented in the mouth. It is attached to the molars by 2 bands and has two or four active helix springs that widen the arch of the mouth to make room for crowded teeth, or correct a posterior cross-bite, where lower teeth are buccal (outer) than upper teeth.

 

        v  Provides continuous, controlled force for a variety of applications

        v  Allows for a differential amount of expansion in the anterior and posterior region of the arch

        v  Reshaping of maxillary arch form

        v  Molar derotation (Class II correction)

        v  Anchorage and torque control in tandem with archwire

        v  Incisors alignment and placement

        v  Oral habit correction, when evident

        v  Vertical control - tongue influence with slow expansion

        v  Ease of placement in one appointment (pre-formed RMO Quad)

 

 

v  Warranty regarding extension, retention, occlusion, contact etc. is only on the basis of the given model.

v  All repetitions and correction should be informed within 7 days and will be accepted only with fresh models along with initially supplied model, work and warranty card.

v  To claim warranty of Pine Dental prosthesis, the patient should consult the same doctor or clinic.

v  Repetitions will be charged at 50% of the actual rate of the work and additional tax, if any.

v  Patient cannot claim warranty in the pricelist will not have any warranty.

Request:

v  We need 7 working days to complete a work except Friday and other holidays.

Urgent Orders

v  Will be charge 10% extra. The fabrication time depends on prosthesis type and unit.

Suggestion

v  The proximal margins of the abutments should be parallel or slightly tapering towards occlusal surface. Eliminate undercuts to the maximum. Round all corners.

v  We always prefer perfect rubber base impression. Don’t pour die stone type IV immediately to the rubber base impression. Pour only after 1 hour.

v  Don’t allow the alginate impression to get dried. Pour die stone type IV immediately. If the model thus prepared is found defective (air bubble, broken stump etc.) discard it and take a new impression rather than trying to produce a second model from the old alginate impression.

v  We need upper and lower full Die Stone IV models to check the occlusion correctly.

v  Provide the bite registration in Silicone putty (not in wax), if necessary.

v  The shade will be perfect only if the labial and occlusal clearance is 2mm.

v  VITA classical and VITA 3D Master 9of Ivoclar A-D shade number should be given for ceramic shade selection.

v  Avoid grinding the metal prosthesis at the time of metal trial. This may lead to contamination of metal and ceramic chipped – off.

v  In anterior case, if the patient is satisfied with the temporary crown / bridge, kindly provide a model of that which will help us in imitating the shape and arrangement. Pre – operative models will also be useful in some cases.

 


Other Products

ACRYLIC DENTURE

Additional teeth and denture base can easily be added to an existing Acrylic Denture. It is also the product

Get Details

ACRYLIC DENTURE - BREDENT

Rapid Maxillary Expansion

Is a preliminary treatment procedure that aims at enlarging the maxillary dental arch and the palate

Get Details

RME

Study Model

A dental impression is a negative imprint of hard (teeth) and soft tissues in the mouth from which a positive reproduction

Get Details

STUDY MODEL

PINE ZIRCONIA

Zirconia crowns allow light to pass as a normal tooth would and that gives a natural look, unlike other metal cores that block the light...

Get Details

METAL FREE