Hawley Appliance may be used passively to retain teeth in their new position following orthodontic
ESSIX CLEAR RETAINER guide and maintain the position and alignment of teeth to create an attractive smile, and today there's quite a range to choose from. Essix retainers, in particular, are clear, slim molds that fit over your teeth. Your orthodontist might recommend an Essix retainer as the final stage in a course of orthodontic treatment, or as a complete alternative to braces.
v Maintaining the position and alignment of tooth
v Create Attractive smile
v Prevent of tooth wear due to tooth grinding at night
v Warranty regarding extension, retention, occlusion, contact etc. is only on the basis of the given model.
v All repetitions and correction should be informed within 7 days and will be accepted only with fresh models along with initially supplied model, work and warranty card.
v To claim warranty of Pine Dental prosthesis, the patient should consult the same doctor or clinic.
v Repetitions will be charged at 50% of the actual rate of the work and additional tax, if any.
v Patient cannot claim warranty in the pricelist will not have any warranty.
need 7 working days to complete a work except Friday and other
v Will be charge 10% extra. The fabrication time depends on prosthesis type and unit.
v The proximal margins of the abutments should be parallel or slightly tapering towards occlusal surface. Eliminate undercuts to the maximum. Round all corners.
v We always prefer perfect rubber base impression. Don’t pour die stone type IV immediately to the rubber base impression. Pour only after 1 hour.
v Don’t allow the alginate impression to get dried. Pour die stone type IV immediately. If the model thus prepared is found defective (air bubble, broken stump etc.) discard it and take a new impression rather than trying to produce a second model from the old alginate impression.
v We need upper and lower full Die Stone IV models to check the occlusion correctly.
v Provide the bite registration in Silicone putty (not in wax), if necessary.
v The shade will be perfect only if the labial and occlusal clearance is 2mm.
v VITA classical and VITA 3D Master 9of Ivoclar A-D shade number should be given for ceramic shade selection.
v Avoid grinding the metal prosthesis at the time of metal trial. This may lead to contamination of metal and ceramic chipped – off.
v In anterior case, if the patient is satisfied with the temporary crown / bridge, kindly provide a model of that which will help us in imitating the shape and arrangement. Pre – operative models will also be useful in some cases.
Zirconia crowns allow light to pass as a normal tooth would and that gives a natural look, unlike other metal cores that block the light...
It’s typically made of a flexible material that molds to your teeth. It may not fit perfectly since the mold
Lengthens the lower jaw by posturing it forward. It can also be used to cure an overbite, which can mean