Is a type of overdenture that is supported by and attached to implants. A regular denture
PINE PFM provides the perfect combination of strength and ensures your ideal fit, contacts and occlusion, and lifelike esthetics that allows you to deliver long – lasting smile.
It is classified into:
v Pine CAD/CAM PFM
v Pine Conventional PFM
Both are available as:
v Excellent fit and marginal integrity
v Perfect combination of strength and esthetics
v High Biocompatible
v Single crown
v Equal or more than 6 units of bridge
v Full mouth rehabilitation
v Full mouth rehabilitation
v Warranty regarding extension, retention, occlusion, contact etc. is only on the basis of the given model.
v All repetitions and correction should be informed within 7 days and will be accepted only with fresh models along with initially supplied model, work and warranty card.
v To claim warranty of Pine Dental prosthesis, the patient should consult the same doctor or clinic.
v Repetitions will be charged at 50% of the actual rate of the work and additional tax, if any.
v Patient cannot claim warranty in the pricelist will not have any warranty.
v Ensure giving temporary crown or bridge after tooth preparation. We won’t be responsible for problems in insertion, if temporary crown or bridge is not given.
v An order placed, cannot be withdrawn.
v We need 7 working days to complete a work except Friday and other holidays.
v Will be charge 10% extra. The fabrication time depends on prosthesis type and unit.
v The proximal margins of the abutments should be parallel or slightly tapering towards occlusal surface. Eliminate undercuts to the maximum. Round all corners.
v We always prefer perfect rubber base impression. Don’t pour die stone type IV immediately to the rubber base impression. Pour only after 1 hour.
v Don’t allow the alginate impression to get dried. Pour die stone type IV immediately. If the model thus prepared is found defective (air bubble, broken stump etc.) discard it and take a new impression rather than trying to produce a second model from the old alginate impression.
v We need upper and lower full Die Stone IV models to check the occlusion correctly.
v Provide the bite registration in Silicone putty (not in wax), if necessary.
v The shade will be perfect only if the labial and occlusal clearance is 2mm.
v VITA classical and VITA 3D Master 9of Ivoclar A-D shade number should be given for ceramic shade selection.
v Avoid grinding the metal prosthesis at the time of metal trial. This may lead to contamination of metal and ceramic chipped – off.
v In anterior case, if the patient is satisfied with the temporary crown / bridge, kindly provide a model of that which will help us in imitating the shape and arrangement. Pre – operative models will also be useful in some cases.
It’s typically made of a flexible material that molds to your teeth. It may not fit perfectly since the mold
Ideal material for creating highly esthetic full-contour restorations.
Is used as an anchorage appliance to hold molars in place while the patient continues with traditional bands and