CERCON is an excellent material choice for metal – free restorations because of its biocompatibility, strength, durability and beauty. It allows computer aide scanning, milling, grinding, sintering and designing that is perfectly suited for anterior and posterior region. It is use for a wide variety of restoration from single crown to long-span bridges and providing excellent aesthetic and perfect marginal fit. 

It is available as:

v Cercon HT

v Cercon

v Cercon HT Full Contour

 

       v   High biocompatible, strength and durability


v    Excellent aesthetic


v    Perfect marginal fit



       v    3 Single crown or multi-unit bridge (anterior and posterior region)


v    3 units inlay bridges

v  Warranty regarding extension, retention, occlusion, contact etc. is only on the basis of the given model.

v  All repetitions and correction should be informed within 7 days and will be accepted only with fresh models along with initially supplied model, work and warranty card.

v  To claim warranty of Pine Dental prosthesis, the patient should consult the same doctor or clinic.

v  Repetitions will be charged at 50% of the actual rate of the work and additional tax, if any.

v  Patient cannot claim warranty in the pricelist will not have any warranty.

Request:

v  Ensure giving temporary crown or bridge after tooth preparation. We won’t be responsible for problems in insertion, if temporary crown or bridge is not given.

v  An order placed, cannot be withdrawn.

v  We need 7 working days to complete a work except Friday and other holidays.

Urgent Orders

v  Will be charge 10% extra. The fabrication time depends on prosthesis type and unit.

Suggestion

v  The proximal margins of the abutments should be parallel or slightly tapering towards occlusal surface. Eliminate undercuts to the maximum. Round all corners.

v  We always prefer perfect rubber base impression. Don’t pour die stone type IV immediately to the rubber base impression. Pour only after 1 hour.

v  Don’t allow the alginate impression to get dried. Pour die stone type IV immediately. If the model thus prepared is found defective (air bubble, broken stump etc.) discard it and take a new impression rather than trying to produce a second model from the old alginate impression.

v  We need upper and lower full Die Stone IV models to check the occlusion correctly.

v  Provide the bite registration in Silicone putty (not in wax), if necessary.

v  The shade will be perfect only if the labial and occlusal clearance is 2mm.

v  VITA classical and VITA 3D Master 9of Ivoclar A-D shade number should be given for ceramic shade selection.

v  Avoid grinding the metal prosthesis at the time of metal trial. This may lead to contamination of metal and ceramic chipped – off.

v  In anterior case, if the patient is satisfied with the temporary crown / bridge, kindly provide a model of that which will help us in imitating the shape and arrangement. Pre – operative models will also be useful in some cases. 


Other Products

Nance Appliance

Is used as an anchorage appliance to hold molars in place while the patient continues with traditional bands and

Get Details

Nance Appliance

Habit Breaker Appliance

we use is the tongue crib, which is a fixed appliance that keeps your tongue positioned posteriorly.

Get Details

Habit Breaker

Essix Clear Retainer

Guide and maintain the position and alignment of teeth to create an attractive smile

Get Details

ESSIX CLEAR RETAINER

PINE ZIRCONIA

Zirconia crowns allow light to pass as a normal tooth would and that gives a natural look, unlike other metal cores that block the light...

Get Details

METAL FREE