Is an appliance that is custom-made by a dentist or orthodontist in acrylic or metal material.
Due to its high translucency, Zenostar (IVOCLAR) is the ideal material for creating highly esthetic full-contour restorations. Alternatively, the material can also be used to fabricate substructures or combinations consisting of monolithic, partial and fully veneered parts.
vOptimized optical and mechanical properties.
vMinimal wear to opposing dentition due to low abrasive properties when the restoration is polished.
vConsistent strength over time as a result of high resistance to hydrothermal aging.
vMinimal expansion and contraction of the restoration caused by low thermal conductivity
vSingle unit restorations as well as up to 3-unit bridges in the anterior and posterior regions
vSingle unit restorations as thin as 0.4 mm as well as long-span bridges
vThe opacity of Zenostar substructures aides in masking discolored preparations or titanium abutments. Indications include layered single unit restorations and long-span bridges.
v Warranty regarding extension, retention, occlusion, contact etc. is only on the basis of the given model.
v All repetitions and correction should be informed within 7 days and will be accepted only with fresh models along with initially supplied model, work and warranty card.
v To claim warranty of Pine Dental prosthesis, the patient should consult the same doctor or clinic.
v Repetitions will be charged at 50% of the actual rate of the work and additional tax, if any.
v Patient cannot claim warranty in the pricelist will not have any warranty.
v Ensure giving temporary crown or bridge after tooth preparation. We won’t be responsible for problems in insertion, if temporary crown or bridge is not given.
v An order placed, cannot be withdrawn.
v We need 7 working days to complete a work except Friday and other holidays.
v Will be charge 10% extra. The fabrication time depends on prosthesis type and unit.
v The proximal margins of the abutments should be parallel or slightly tapering towards occlusal surface. Eliminate undercuts to the maximum. Round all corners.
v We always prefer perfect rubber base impression. Don’t pour die stone type IV immediately to the rubber base impression. Pour only after 1 hour.
v Don’t allow the alginate impression to get dried. Pour die stone type IV immediately. If the model thus prepared is found defective (air bubble, broken stump etc.) discard it and take a new impression rather than trying to produce a second model from the old alginate impression.
v We need upper and lower full Die Stone IV models to check the occlusion correctly.
v Provide the bite registration in Silicone putty (not in wax), if necessary.
v The shade will be perfect only if the labial and occlusal clearance is 2mm.
v VITA classical and VITA 3D Master 9of Ivoclar A-D shade number should be given for ceramic shade selection.
v Avoid grinding the metal prosthesis at the time of metal trial. This may lead to contamination of metal and ceramic chipped – off.
v In anterior case, if the patient is satisfied with the temporary crown / bridge, kindly provide a model of that which will help us in imitating the shape and arrangement. Pre – operative models will also be useful in some cases.
Is an excellent material choice for metal – free restorations because of its biocompatibility, strength, durability and beauty.
Is used as an anchorage appliance to hold molars in place while the patient continues with traditional bands and
A dental implant is placed in the jawbone so that it can fuse with your natural bone