A cast thermo plastic denture that is thin, lightweight, and flexible with invisible clasps that surround the natural teeth.
TWIN BLOCK lengthens the lower jaw by posturing it forward. It can also be used to cure an overbite, which can mean treatment may be slightly longer.
A simple bite blocks that are designed for full-time wear. They achieve rapid functional correction of malocclusion by the transmission of favourable occlusal forces to occlusal inclined planes that cover the posterior teeth. The Twin Block appliance can be designed like any other removable orthodontic appliance with a variety of components such as expansion screws, springs and clasps.
v COMPLIANCE –comfortable for patient to wear
v VERSATILE – offer independent control of arch form
v RAPID CORRECTION – 24 hour wear achieves rapid correction of malocclusion
v VERTICAL – excellent to increase vertical in deep bite cases
v Warranty regarding extension, retention, occlusion, contact etc. is only on the basis of the given model.
v All repetitions and correction should be informed within 7 days and will be accepted only with fresh models along with initially supplied model, work and warranty card.
v To claim warranty of Pine Dental prosthesis, the patient should consult the same doctor or clinic.
v Repetitions will be charged at 50% of the actual rate of the work and additional tax, if any.
v Patient cannot claim warranty in the pricelist will not have any warranty.
need 7 working days to complete a work except Friday and other
v Will be charge 10% extra. The fabrication time depends on prosthesis type and unit.
v The proximal margins of the abutments should be parallel or slightly tapering towards occlusal surface. Eliminate undercuts to the maximum. Round all corners.
v We always prefer perfect rubber base impression. Don’t pour die stone type IV immediately to the rubber base impression. Pour only after 1 hour.
v Don’t allow the alginate impression to get dried. Pour die stone type IV immediately. If the model thus prepared is found defective (air bubble, broken stump etc.) discard it and take a new impression rather than trying to produce a second model from the old alginate impression.
v We need upper and lower full Die Stone IV models to check the occlusion correctly.
v Provide the bite registration in Silicone putty (not in wax), if necessary.
v The shade will be perfect only if the labial and occlusal clearance is 2mm.
v VITA classical and VITA 3D Master 9of Ivoclar A-D shade number should be given for ceramic shade selection.
v Avoid grinding the metal prosthesis at the time of metal trial. This may lead to contamination of metal and ceramic chipped – off.
v In anterior case, if the patient is satisfied with the temporary crown / bridge, kindly provide a model of that which will help us in imitating the shape and arrangement. Pre – operative models will also be useful in some cases.
Zirconia crowns allow light to pass as a normal tooth would and that gives a natural look, unlike other metal cores that block the light...
A dental implant is placed in the jawbone so that it can fuse with your natural bone
It is used to widen the palate, or the roof of the mouth. It is most often used on