Is designed and precision milled with CAD/CAM technology. It provides the perfect combination of strength
BPS HYBRID DENTURE were designed to combine advanced technology
and material with proven techniques resulting in dentures with the best
aesthetics, function and form. The BPS dentures are considered to be the best
solution to tooth loss, providing patient with optimum function while laughing,
speaking or eating. These premium quality denture instil confidence and provide
Top quality materials are used to resist staining, chipping and wear. Measurements of your jaw and face are used to create a personalized denture that will suit your individual looks and needs.
v Comfort : reduced irritation to gums
v Strength : extremely dense material reduces the chance of breakage
v Cleanliness : Its non porous surface greatly mitigates odour causing bacteria and plaque.
v Aesthetics : natural looking so you can smile, speak and laugh with confidence
v Less chair time and fewer adjustments
v Warranty regarding extension, retention, occlusion, contact etc. is only on the basis of the given model.
v All repetitions and correction should be informed within 7 days and will be accepted only with fresh models along with initially supplied model, work and warranty card.
v To claim warranty of Pine Dental prosthesis, the patient should consult the same doctor or clinic.
v Repetitions will be charged at 50% of the actual rate of the work and additional tax, if any.
v Patient cannot claim warranty in the pricelist will not have any warranty.
need 7 working days to complete a work except Friday and other
v Will be charge 10% extra. The fabrication time depends on prosthesis type and unit.
v The proximal margins of the abutments should be parallel or slightly tapering towards occlusal surface. Eliminate undercuts to the maximum. Round all corners.
v We always prefer perfect rubber base impression. Don’t pour die stone type IV immediately to the rubber base impression. Pour only after 1 hour.
v Don’t allow the alginate impression to get dried. Pour die stone type IV immediately. If the model thus prepared is found defective (air bubble, broken stump etc.) discard it and take a new impression rather than trying to produce a second model from the old alginate impression.
v We need upper and lower full Die Stone IV models to check the occlusion correctly.
v Provide the bite registration in Silicone putty (not in wax), if necessary.
v The shade will be perfect only if the labial and occlusal clearance is 2mm.
v VITA classical and VITA 3D Master 9of Ivoclar A-D shade number should be given for ceramic shade selection.
v Avoid grinding the metal prosthesis at the time of metal trial. This may lead to contamination of metal and ceramic chipped – off.
v In anterior case, if the patient is satisfied with the temporary crown / bridge, kindly provide a model of that which will help us in imitating the shape and arrangement. Pre – operative models will also be useful in some cases.
Is an orthodontic appliance for the upper teeth that is cemented in the mouth. It is attached to the molars
Zirconia crowns allow light to pass as a normal tooth would and that gives a natural look, unlike other metal cores that block the light...
Lengthens the lower jaw by posturing it forward. It can also be used to cure an overbite, which can mean